Tekno Point DKV Series, Installation Manual

Page: 44 / 48

Indoor unit installation
Install the rear panel
Install the piping hole
Install the water drainage pipe
Wrenched
Bent
Outdoor Indoor
Flooded
Wall pipe
Seal pad
Fig.1
(Rear piping hole)
(Rear piping hole)
Left Right
Mark on the middle of it
Gradienter
Space to
the wall
150mm
above
Space to
the wall
150mm
above
Wall
1. Always mount the rear panel horizontally. As the water drainage
Wall
Connect indoor and outdoor electric wires
kèlhling pipe at the left, when adjusting the rear panel, this side should not be too high; the
right side should be slightly high.
2. Fix the rear panel on the selected location
3. Be sure that the rear panel has been
fixed firmly enough to with stand the
weight of an adult of 60 kg, furthermore,
the weight should be evently shared by
each screw.
1. Make the piping hole in the wall at a slight downward slant to the
outdoor side.
2. Insert the piping-hole sleeve into the hole to prevent the connection
piping and wiring from being damaged when passing through the hole.
1. For well draining, the drain hose should be placed at a
downward slant.
2. Do not wrench or bend the drain hose or flood its end by
water. 3. When the long drainage hose passing through
indoor, should wrap the insulation materials.
1. Open the front panel upwardly.
2. Screw off the fixing screw of cover plate and screw off cover plate.
3. Put the power connection cable through the back of indoor unit wire hole and
take it out.
4. All the wiring should be connected according to the circuit diagram on the unit.
5. Put the power connection cable the section, which with sheath into wire groove,
and cover the cover plate, screw on the fixing screw, tighten the connection wire.
6. Cover the front panel cover.
7. For the cooling and heating unit, signal control wire can be passed through the
connection of connector and indoor unit, and use the wire clip that is under the
body case, tighten the signal control wire.
44