Tekno Point DKV Series, Installation Manual

Page: 42 / 48

Installation service- Notices for installation
Important Notices
Basic Requirements For Installation Position
Indoor Unit Installation Position Selection
1. The unit installation work must be done by qualified personnel according to the local
rules and this manual.
2. If the air conditioner has not plug, directly connect it into the fixed circuit, a breaker should
be installed in the fixed circuit. all pole of this breaker should be switching off and the
distance of the contact should be at least 3mm.
Install in the following place may cause malfunction. If it is unavoidable contact with
service center please:
- Place where strong heat sources, vapors, flammable gas or volatile objuct are emitted.
- Place where high-frequency waves are generated by radio equipment, welders and
medical equipment.
- Place where a lot of salinities such as coast exists.
- Place where the oil (machine oil) is contained in the air.
- Place where a sulfured gas such as the hot spring zones is generated.
1. The air inlet and outlet vent should be far from the obstruction, make sure that the air
can be blown through the whole room.
2. Select a position where the condensing water can be easily drained out, and the place
is easily connected for outdoor unit.
3. Select a location where the children can not reach.
4. Can select the place where is strong enough to withstand the full weight and vibration
of the unit. And will not increase the noise.
5. Be sure to leave enough space to allow access for routine maintenance. The height of
the installed location should be 230 cm or more from the floor.
6. Select a place about 1m or more away from TVset or any other electric appliances.
7. Select a place where the filter can be easily taken out.
8. Make sure that the indoor unit installation should accord with installation dimension
42