General Features
✓
TLPWAN low power consumption, two-way safe and stable wireless communication protocol
✓
Standard, low cost lithium battery
✓
Up to 6 years battery life
✓
EN54-3, EN54-23, EN54-25 Certified
Indicator LEDs
Condition
LED Signal Pattern
Any error situation
(Tamper etc.)
Heart LED blinks once in every 10 seconds
Device in normal operation mode
Heart LED blinks once in every 20 seconds
Low battery warning
Heart Led blinks once in every 10 seconds
Network connection-disconnection
Result of operation
Green LED blinks twice in every 2 seconds
Affirmative, green LED lights for 3 seconds
Not Affirmative, red LED lights for 3 seconds
Connection quality
Connection Quality is Good; Green LED blinks 3 times
Connection Quality is Medium; Green LED blinks 2 times
Connection Quality is Poor; Green LED blinks once
No Connection; Red LED blinks once
Changing Siren and Flasher Modes
Connection /Test Button
Flasher Turns On/Off when pressed long
Connection /Test Button
Flasher Mode changes when pressed shortly
Connection /Test Button
Siren Turns On/Off when both of them pressed
simultaneously
Tamper Key
Siren mode changes when pressed shortly
Network Connection Procedure
In order for a device to join the network, that device must not have been included in any network before.
Whether the device has joined any network or not can be determined by the link test. Follow the steps below
for connecting the device to a network.
1.
The connection permission on the coordinator or on the router must be on before the device is
connected to a network. Turn on the connection permission on the coordinator or on the router.
2.
Press long (for 5 seconds) on the “Connection/
Test
” button
located under the device.
3.
The device will start the connection procedure automatically. This procedure takes about 20 to 60
seconds. The green LED will blink twice every 2 seconds during the procedure.
4.
At the end of the procedure, the green LED will light for 3 seconds if the connection procedure is
successful, and the red LED will light for 3 seconds if the connection procedure is not successful.
Disconnection procedure
1.
Press long (for 5 seconds) on the “Connection/
Test
” button
located under the device.
2.
The device will start the disconnection procedure automatically. The green LED will light for 3 seconds
at the end of the procedure.
Link Test
It is possible to measure the link quality between the device and the connected coordinator or router. For this,
press shortly on the
“Connection/
Test
”
button located under the device. If the device is connected to a network,
the LEDs will light as noted below at the end of the procedure:
EN 54-23 Visual Alarm Devices A
–
Intensive Volume Level Figure (max.)
Manufacturer
*In compliance with AEEE regulations. This product is manufactured with recyclable and reusable high quality
parts and materials. Do not dispose of the product together with domestic or other wastes at the end of its
service lifetime. Take it to a drop-off point for the recycling of electrical and electronic devices.
Bilgi Elektronik San. ve Tic. A.Ş.
Dudullu Organize Sanayi Bölgesi 1. Cadde İsmet Tarman İş Merkezi
No:1 Kat:2 No:32 Ümraniye / İstanbul
/ Türkiye
Phone Number:
+90 216 455 88 46
Fax:
+90 216 455 99 06
Warning:
After adding the device to the network, proceed the link test at the location of the device will
work. If there is no connection in the link test, the system will not work properly. In this case, change
the location of the device.
