Teknik GC1035, Manual

Page: 8 / 17

8
the DIS/NOTCH range to the right.
DISC/NOTCH indicator shows detector’s current
discrimination range, and a
n object’s probable identification is indicated by the arrows at
the top of the display. SENS shows current sensitivity level. While DEPTH reads out the
estimated target depth. Each time a target is detected, DEPTH indicator will illuminate.
DEPTH indicator shows the relative depth of the target, the larger the reading is, the
farther the target away from the coil.
Adjusting DISC Range
：
Press ADJ, the display bar of DISC/NOTCH range will blink. Now you can adjust
DISC/NOTCH range. Press“
+”
to increase the
range of discrimination, press “
-
” to
decrease it.
2.ALL METAL Mode
— Press MODE to enter into ALL METAL mode, the detector now
is in non-motion mode. In this mode, the detector emits only a monotone sound when it
finds a target, and DEPTH indicates relative target signal strength. The stronger the
signal is, the louder the tone is. GND TRAC is used to locate a coin-sized object
precisely. To move the coil above or near the target area, target will be found soon.
Please make sure the detector is well ground balanced before using ALL METAL mode.
(Please refer to Ground Balancing and PINPOINTING in Non-motion mode.)
Target identification is useless in ALL METAL mode. To see target identification and
depth, please change the detector into relative motion mode.
3.NOTCH Mode
— To selectively eliminate one or several metals from the categories,
you can use NOTCH mode. DISC/NOTCH indicator shows current target discrimination
range, and the probable target identification is indicated by the arrows at the top of the
display. SENS shows current sensitivity level. While DEPTH indicates the probable target
depth.
Adjusting Target NOTCH Range
：
In NOTCH mode, press ADJ to enter into
DISC/NOTCH range setting status. LCD display bar blinks. Press + or - touch pad , one
of the arrows in target indicator will flash, press ENT to accept or reject the
corresponding metal target. Press again + or -, its right or left arrow will flash, then press
ENT to accept or reject another metal target which the current arrow pointing to. Same as
the others…
4.AUTO-NOTCH Mode
— When the detector is working in AUTO-NOTCH
mode
（
LCD
shows “AUTO-NOTCH” at the bottom
）
, it eliminates trash metals automatically and keep
the detection for coins. Eliminated trash metals include: Bottle caps, S-CAPS,
IRON/FOIL, Pull Tab. DISC/NOTCH range
（
not adjustable
）
displays current target
identification range. And a
n object’s probable identification is indicated by the arrows at
the top of the display. SENS shows current sensitivity level. While DEPTH indicates the
proba
ble target’s depth.