Step 2
Page 6
å
Separate the EXTENSION SLIDES (35MC) from the EXTENSION RAILS (35MA) as
shown in the upper diagram below. Be prepared, the parts are greasy.
å
Fasten one EXTENSION RAIL (35MA) to the RIGHT END (A). Use two SILVER 1/2" FLAT
HEAD SCREWS (128S) through holes #1 and #3.
å
NOTE: For the EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged
diagram. Then, slide the inner cartridge of the EXTENSION RAIL in to find the other hole
that lines up with the hole in the END. Turn a SCREW into this hole.
å
NOTE: The EXTENSION SLIDES (35MC) will be used later for the DRAWER.
Open end
Push the black lever in and pull the SLIDE from the RAIL.
35MA
35MC
1
2
3
SILVER 1/2" FLAT HEAD SCREW
(2 used for the RAIL)
128S
Edge with
TWIST-LOCK®
FASTENERS
A
