H u d s o n M a n u a l / R e v . 1 . 2 1
9
T
EKNIC
,
I
NC
.
P H O N E ( 5 8 5 ) 7 8 4 - 7 4 5 4
Interconnect and Wiring
This section discusses Hudson motor interconnect topics, including the
following:
•
Motor connector options
•
Mating connector parts and pinout information
Motor Connector Options
Hudson motors are available in two connector options:
Molex MiniFit Jr.
(at
left below) and
Souriau Trim-Trio
, free hanging (at right).
Hudson motor connector options
Molex Mini-Fit Jr. Connector
The Molex Mini-Fit Jr. connector provides a gas tight link with four points of
contact. This low cost, rugged connector is rated at up to 10A continuous
current per circuit, and 600V. The connector includes a positive locking
mechanism, and fully isolated, low engagement-force terminals.
Use Molex Mini-Fit Jr. connectors when:
•
Lower cost and high reliability is required
•
The operating environment is relatively clean and dry (typical dust/dirt
is OK)
•
Less than 10A of continuous current per phase is required
Souriau Trim-Trio Connector
The Souriau Trim-Trio bayonet-style connector is a keyed, sealed, positively
locking unit derived from the MIL-C 26482 specification.
Use Souriau Trim-Trio connectors when:
•
The pollution level (at the connector) is higher (light spray, mists,
fumes, chips, etc.)
•
A water resistant seal (at the connector) is required
•
Higher current-carrying capacity (> 10A continuous) is required
