햷
____________________________________
LED Flashlight:
1.Start with power off.
2.Press-and-hold button. Continue to hold. Light will turn on and flash.
3.Continue to press-and-hold button.
• As long as you continue to hold the button, the Pinpointer
will cycle through various brightness settings.
• At the brightest setting, the light will flash.
4.Release the button at your desired level of illumination.
• Alarm will confirm program is set (beep, vibrate or both).
5.Device is powered on; ready to hunt.
Frequency Shift:
(To eliminate interference with detector)
1. Turn Pinpointer power off.
2. Turn your detector on.
3. Turn Pinpointer on.
4. Press-and-hold button. Do not release the button at the first alarm
(Power-down-alarm) or programming alarm (JINGLE-JINGLE-JINGLE).
5. Release the button when you hear the double tone-roll.
6. Device is now in frequency-shift mode.
Each press-and-release will change the frequency of the pin-
pointer; a short beep confirms this action.
There are 16 different frequencies to choose from. A double-beep
means you’ve cycled through all 16 frequencies; continue to
press-and-release to continue cycling through frequencies.
7. When you reach the desired frequency your pinpointer will not
interfere with your detector.
8. At this point do not press the button again; the pinpointer will alarm, in-
dicating programming is complete and that the device is ready to hunt.
Re-Boot:
If pinpointer becomes unresponsive or locks-up,
perform re-boot sequence:
1. Remove the battery door (to break battery contact).
2. Replace battery door. Power on to resume operation.
CONTINUED
QUICK START
