TEKNETICS
Comprehensive Operating Manual & Guide to Metal Detecting
7
Arm Rest Position on Pole:
Remove the two bolts to position the armrest farther forward
or back, to adapt to your arm’s length.
— To reinsert the bolts, spin and twist them into place. Be careful not to damage the
power cable that runs through the aluminum tube.
— Insert both bolts completely through both sides of the bracket
before attaching the nut
to the opposite side.
— For maximum stability, the bolts fit very tightly into the holes; you may have to wiggle
each one a bit to push it through the holes.
— After reinserting the bolts, tighten them very securely. As you swing the detector from
side-to-side, you want the bolts tight enough so that you do not feel any movement
between the pole and armrest mounting bracket.
If you notice unwanted movement while swinging detector, check the tightness
of the locking collars
. The locking collars must be rotated a full 270° to reach the
locking position.
HEADPHONES (not included)
The
T
2+
is equipped with a standard 1/4-inch stereo headphone jack at the rear of the unit,
located under the elbow as you hold the detector for use. Any headphone with a 1/4”
stereo jack should work. Mono headphones will not work.
Using headphones improves battery life, and prevents the sounds from annoying bystanders.
It also allows you to hear subtle changes in the sound more clearly, particularly if
searching in a noisy location.
For safety reasons, do not use headphones near traffic or where other dangers, like
rattlesnakes, are present.
This device is to be used with interconnecting cables/headphone cables shorter than three
meters.
MECHANICALS (continued)
Adjust the armrest in or out accordingly
Adjust the armrest forward or back, to adapt to
your arm’s length.