12
weather channel for alerts (The speaker will still sound even if no signal is received). When it
detects
WX
Alert signal, your radio will alarm for 5 sec every time and the duration is longer
than 600ms, and
ALT
icon will flash and listen to
WX
broadcasting.
1).
To turn on the WX mode and choose a weather channel
:
• Pressing
WX
key switches between GMRS/FRS and
WX
mode until the
WX
icon on the
display is shown.
• Select WX Channel in WX mode by pressing
Up/Down
key.
2).
To Enable WX alert setting
:
• Holding down
WX
Key for 2 seconds enables (or disable)
WX
Alert feature, the
ALT
icon will
show.
• Pressing
PTT
key or no any key operation for 15 seconds confirms the setting.
14. Reset Feature
The radio can be reset to the default value that it was made in the factory.
To reset your radio:
• Press
Func
key to turn on the radio.
15. Charging battery
When you use Ni-MH batteries and begin to recharge your batteries, the
CHARGE ON/OFF
switch (inside the battery compartment) should be set to the position of
ON
. Open the battery door,
and you will find this switch.
1).
Using standard charging cradle
• Trickle charge method is used.
2).
Using 21-1930 charging cradle
• For fast charge, the radio is required to power off first and then plugged into the charger.
• If radio is
ON
while charging, trickle charge method is used.
3).
Using CLA jack
• Before connect the Adapter plug, make sure setting
CHARGE ON/OFF
switch to
ON
inside
the radio, otherwise battery level meter icon will appear on the display improperly.
• The radio can be used and charged at the same time when using CLA jack.
Note:
Do not set the switch at the position of
ON
when Alkaline batteries are being used. It may cause
the radio to burst and cause personal injury when you recharge the batteries.
Summary of Contents for 21-01904
Page 14: ...14 10 94 8 20 131 8 30 186 2 ...
