BA_LMD-508_150602_GB.doc
- 6 -
02.06.2015
•
Do not operate the equipment without a filter insert!
•
Disconnect the equipment from the supply voltage before opening the filter unit!
•
The exhaust vent must not be covered up or blocked!
•
Always take care that the unit is standing in a stable position, and that the brakes on the castors
are on!
•
The filter unit must be disconnected from the mains supply voltage before cleaning or
maintenance, replacing parts, or a functional conversion!
•
The filter inserts cannot be regenerated!
•
Dispose of the filter inserts in accordance with the legal regulations!
•
If an energy-saving automatic start/stop is being used, the earthing cable must be checked for
possible damage before every welding session.
•
The unit must not be used if the earthing cable is not in perfect condition.
•
If external filter controls are used, the control cable must be checked for possible damage
before every operating session.
•
The unit must not be used if the control cable is not in perfect condition!
•
The mains supply cable for the unit must be checked regularly for possible damage!
•
The unit must not be used if the mains supply cable is not in perfect condition!
•
Do not use the filter unit if one or more of its components are faulty, missing, or damaged. In
any of these cases, please call the TEKA service department on +49 (0)2863 92820, or your
local representative.
•
When extracting carcinogenic welding fumes, such as from materials containing nickel or
chrome, the ventilation requirements of TRGS 560 „Luftrückführung beim Umgang mit
krebserzeugenden Gefahrstoffen“ (Air recycling when using substances with a carcinogenic
hazard) or the equivalent national regulations must be fulfilled!
Further information on TRGS 560 can be obtained from the BfA - Berufsgenossenschaftliches
Institut für Arbeitssicherheit, in D-53754 Sankt Augustin, Germany.
5 Commissioning
The filter unit is supplied with all connections.
The extractor fittings and any other accessory equipment, must be installed or mounted on the unit
before commissioning.
5.1 Attaching the extractor fittings
•
The extractor hose must be pushed into the extractor spout (Pos.16) right up to the stop. If a
second hose is used, this is done as follows:
•
Remove the blanking plug from the extractor spout (Pos.16).
•
Push the extractor hose into the extractor spout (Pos.16) right up to the stop.
