GB
8
INSTALLATION AND SETUP SHOULD
BE CARRIED OUT BY AN AUTHORISED
TECHNICIAN IN LINE WITH CURRENT
INSTALLATION STANDARDS.
Positioning the hob
To install these models, an opening with
the dimensions shown in figure 1 will be
cut into the unit’s worktop.
The fastening system for the top is desig-
ned for furniture thicknesses of 20, 30 and
40 mm.
The minimum distance between the surfa-
ce supporting the cooking pans and the
lower part of the kitchen unit or the hood
located above the hob should be 650 mm.
If the hood’s installation instructions
recommend that the gap is greater than
this, you should follow this advice.
The unit where the hob and oven will be
located will be suitably fixed.
INSTALLATION WITH CUTLERY DRAWER
If you wish to install a tray drawer under
the top, place a cover or partitioning board
at least 5 cm deep from the top in order to
avoid any object placed on the drawer
obstructing the top ventilators. In this man-
ner, we will also avoid any potential risk to
inflammable objects that may be stored in
the drawer.
INSTALLATION
WITH
FAN
OVEN
UNDER THE HOB
The oven should be installed according to
the corresponding manual.
If a fan oven is being installed, please
remember that this hob has only been cer-
tified to work with TEKA brand ovens.
Installation
fig. 1
57
5 m
ax.
W
L
Minimum distance
to wall
Minimum ventilation
distances
DRAWER
OVEN
The dimensions L and W are shown in the table
"Dimensions and characteristics" of the Technical
Information section.
Fitting holes
57
5 m
ax.
W
L
Model IRC 631:
