Gas connection for cooktop
-
.
.
,
. ,
.
,
,
The cooker should be connected to the gas
supply by a qualified installer During
installation of this product it is essential to fit an
approved gas tap to isolate the supply from the
appliance for the convenience of any subsequent
removal or servicing Connection of the
appliance to the gas mains or liquid gas must be
carried out according to the prescribed
regulation in force and only after it is
ascertained that it is adaptable to the type of gas
to be used If connect to liquid gas use pressure
regulators that conform to the regulation in force
for safety for the correct regulation
of gas use and long life of the appliance ensure
that the gas pressure conforms to the indications
given in table
product specifications
Important
:
Check the seal
Electrical connection (if present)
Important
-Earth
-Neutral
-Live
,
.
.
.
-
.
-
,
,
,
.
.
:
;
;
.
:
:
&
,
:
.
.
.
Once the appliance has been installed make sure
all the connections are properly sealed using a
soapy water solution Never use a flame
The cooktops fitted with a tripolar
electrical supply cord are designed to be used
with alternating current according to the
indications on the rating plate located under the
cooktop The earthing wire can be identified by
its yellow green color
In the case of installation over a built in electric
oven the electrical connections for the cooktop
and oven should be independent not only for
safety purposes but also to facilitate removal of
one or both in the future The power supply cord
must be positioned so that it does not reach a
temperature in excess of 50
Before actual connection make sure that
The fuse and electrical system is equipped
with an efficient earth connection
according to the norms and regulations
prescribed by law
That the electrical supply system is
equipped with an efficient earth
connection according to the norms and
regulations prescribed by laws
That the plug or switch are easily
accessible
the wires in the mains lead are
coloured in accordance with the following code
Green Yellow
Blue
Brown
As the colours of the wire in the mains lead
may not correspond with the coloured markings
identifying the teminals in your plug proceed as
follows
“E”or coloured Green or Yellow
Connect the Brown wire to the terminal marked
“L”or coloured Red
Connect the Blue wire to the terminal
marked“N”or coloured Black
o
C above room
temperature at any point
The placement of the burner
A. The placement of Triple Ring
1. Place the triple ring burner properly, and the
must be aimed at the hole of the
burner when install.
2.
Put
and
on
burner properly.
B. The Placement method of Auxiliary Burner is
same as above.
spark plug
burner cap outer
burner cap inter
4.How to use your appliance
The position of the corresponding gas burner or
electric hot plate(if present)is indicated near to
each control knob.
The burner differ in size and power. Choose the
most appropriate one for the diameter of the
cookware being used.
The burner can be regulated with the
corresponding control knob by using one of the
following settings:
Gas burners
Off
High
Low
To light the selected burner ,first press the
corresponding knob down fully, turn it
anticlockwise to the high flame symbol and keep
the knob pressed for approximately 2-3seconds
to allow the safely device “F”to heat up.The gas
can be delivered when the valve is open.
To turn off a burner ,turn the knob clockwise
until it stops (it should be on the “ ”setting).
if the
accidently goes out, turn
off the gas with the control knob and wait at least
1minute before you try to light it again.
Caution:
flame
Burner
Big burner
Small burner
cookware (cm)
26 28
-
10 14
-
Page5
User Manual
Page4
User Manual
Medium burner
16 18
-
For best performance, follow these general
guidelines:
Use the appropriate cookware for each burner
(see table) in
order to prevent the flame
from reaching the sides of the pot or pan;
Always use cookware with a flat bottom and
keep the lid on;
When the contents come to a boil, turn the knob
to “Low”.
