IMPORTANT SAFETY INFORMATION LISTED ON REVERSE
READ, FOLLOW, AND SAVE ALL SAFETY AND INSTALLATION INSTRUCTIONS
RELEASE DATE
5-4-18
40429 Brickyard Drive • Madera, CA 93636 • USA
559.438.5800 • FAX 559.438.5900
www.tekaillumination.com • [email protected]
REFERENCE NUMBER
INS-2690-00
LARGE BEACON STEM MOUNT™ (LBS)
To Replace Components
Fragile! Do not pull on connector or wiring.
Handle with care.
4. Carefully remove LED module from heatsink.
Do not pull on connector or wiring. Handle
with care.
5. Use small pick tool to push connector off LED board
through two small slots behind connector. Once
loose, lift connector upwards and off board.
2. Loosen four (4) #4-40 set screws on dome lens optic
holder using
0.050” Allen wrench. Gently remove
dome lens.
8. Tighten four (4) #4-40 set screws on dome lens
optic holder using
0.050” Allen wrench.
1. Loosen (3) #10-24 set screws on cap with
5/32” Allen wrench. Retain screws in cap.
Twist fixture body, then pull away.
3. Loosen two (2) #4-40 screws with 0.050” Allen
wrench. Gently pull optic holder off heatsink.
Connector will only fit in one direction.
7. Press connector straight downwards into slot
on module to snap into place.
9. Line up body assembly ring to cap. Twist into
cap to secure. Line up holes in body assembly
with holes in cap. Secure by tightening three (3)
#10-24 set screws with 5/32” Allen wrench.
Warning: Do not over tighten set screw.
Doing so will compromise O-Ring seal and
will void warranty.
6. Spread thin, even layer of thermal paste on back
of new LED module. Place new LED module on
heatsink, lining up module with holes for screws.
Tighten two (2) #4-40 screws using 0.050” Allen
wrench to secure LED module to heatsink.
