The Dna 40 uses the resistance of the atomizer to calculate the temperature of
the heating coil.
It continually looks to see whether a new or changed atomizer has been
connected. If you are using temperature protection, be careful to only attach new
atomizers that have cooled to room temperature to the device. If a new atomizer
is attached to the Dna 40 before it has cooled down, the temperature may read
and protect incorrectly until the new atomizer cools.
When you connect a new atomizer or disconnect a reconnect your existing
atomizer, the Dna 40 will prompt you to confirm this change. When you fire the
first time, before activating the Dna 40 will prompt
“ New Coil? UP YES/DOWN
NO”
. When you see this prompt, if you have attached a new atomizer, press the
UP
button. If you have disconnected and reconnected the same atomizer, press
the
DOWN
button.
Operation
Basic operation of the Dna 40 is as follows. To wake the device from power off
state, tap the
Fire
button. To generate vapor, press the
Fire
button. To change
the wattage setting for more or less vapor, click or hold the
UP
and
DOWN
buttons.
Display
The normal and special operating modes shown on display are discussed
below. The Dna 40 will automatically detect whether a temperature sensing
(Nickel 200) or standard Kanthal etc) coil is attached.
Temperature Protected
Watt setting:
The power level currently set on the Dna 40
