seconds. This setting is stored to internal flash memory, and remains if power is
removed.
Right mode and Left mode:
While locked, holding the
Fire
and
UP
buttons
simultaneously for 5 seconds flips the display. This allows for accommodating to
left or right handed use. This setting is stored to internal flash memory, and
remains if power is removed.
Power Locked mode:
Holding down both the
UP
and
DOWN
buttons for 2 seconds
will place the device in Power Locked mode. In this mode, the mod will operate
normally, but you will not be able to change to power setting. This mode prevents
accidental power level change due to the buttons being pressed while in a pocket.
To exit Power Locked mode, hold
UP
and
DOWN
buttons for 2 seconds.
Maximum Temperature Adjust:
From Locked mode, holding down both the
UP
and
DOWN
buttons for 2 seconds will place the device in Max Temperature
Adjust mode. Once this mode is entered, the max temperature will be displayed.
The
UP
and
DOWN
buttons are used to adjust the max temperature. To save the
new temperature setting and exit, press the
Fire
button.
Error Messages:
The Dna 40 will indicate a variety of error states.
Check Atomizer:
The Dna 40 does not detect an atomizer, the atomizer has
shorted out, or the atomizer resistance is incorrect for the power setting.
Shorted:
The atomizer or wiring are shorted circuited.
Weak Battery:
The battery needs to be charged, or a higher rate battery needs to
be used. If this happens, the Dna 40 will continue to fire the atomizer, but will not
be able to provide the desired wattage. The
Weak Battery
message will continue
to flash for few seconds after end of puff.
Temperature protection:
The heating coil reached the maximum allowed
temperature during the puff. If this happens, the Dna 40 will continue to fire, but
will not be able to provide the desired wattage.
