Figure 25:
With the Ergo Embrace logos facing
up, slide the remaining two (2) ankle cups onto
each side of the Front Ankle Bar.
Figure 25
Figure 26
Figure 27
Figure 26:
Insert the Rubber Plugs into the open
ends of the Front Ankle Bar.
TIP:
You may want to use a rubber mallet to
assist with assembly.
Figure 27:
Hand tighten 2 × Screws through the
Front Ankle Bar into the inserted Rubber Plugs.
Proceed to tighten with the Screwdriver.
Figure 24
Figure 24:
Use the
Front Ankle Bar Hardware
Kit
to finish assembling the Front Ankle Bar.
Hand tighten 1 × Screw through the base of the
Front Ankle Bar housing into the set screw slot.
Proceed to tighten with the 5mm Allen Wrench.
14
Summary of Contents for EP-560
Page 24: ...This page intentionally left blank 22 ...
Page 27: ......
