• Locate the three (3) bars for the Small Bar Assembly, marked with Joint
numbers 4, 5, and 6 (Figure 4). Locate the Small Assembly Hardware Kit
(E11061).
• Position the Small Diameter “L” Bar and Small Diameter “Elbow” Bar
together, aligning joints marked as 5 and joints marked as 6 (Figure 5).
•
Assemble Joint 5
(Figure 5A):
»
Seat the curved flange at the end of the “Elbow” Bar over the hole
on the “L” Bar.
»
Insert and loosely hand-tighten a 2 inch (5 cm) bolt through the “L”
Bar into the flange in the “Elbow” Bar. Do not fully tighten yet.
•
Assemble Joint 6
(Figure 5B):
»
Seat the end of the “L” Bar inside the large opening in the Door
Saver on the “Elbow” Bar.
»
Insert and loosely hand-tighten a 2 inch (5 cm) bolt through the
outside of the Door Saver into the end of the “L” Bar. Do not fully
tighten yet.
• Position the Straight Bar and Large Diameter “Elbow” Bar together,
aligning the joint marked as 4 (Figure 6).
•
Assemble Joint 4
(Figure 6A):
»
With the countersink pointing down, align the hole in the Straight
Bar underneath the “Elbow” Bar,
»
Insert the 1 ½ inch (3.8 cm) bolt under the Straight Bar into the
countersink and through the “Elbow” Bar. Hand tighten with the nut.
Do not fully tighten yet.
STEP
Assemble Small Diameter Bars
2
FIGURE 4
FIGURE 5
FIGURE 6
5
6
4
7
4
4
5
5
6
6
FIGURE 5A
FIGURE 5B
FIGURE 6A
Countersink
