Assemble the Upper and Lower Portions of the Table Bed
NOTE: Do not detach the Bed Frame Extension from the clips.
• Locate the Table Bed Assembly Hardware Kit (HK1006)
• Lay the Upper and Lower Portions face down on the floor (Figure 9).
• Gently lift the base of the pre-assembled Bed Frame Extension to slide the Lower Portion
and Frame onto the Upper Portion. Align the shaft of the frame into the plastic track of the
Upper Portion (Figure 10).
• Align the bolt holes of the upper part of the frame (triangle-shaped area) to the bolt holes
on the Upper Portion. Release the Bed Frame Extension so that it rests on top of the bolt
holes (Figure 10).
• Reaching underneath, insert one of the shorter bolts through one of the holes in the Upper
Portion and hold in place. Slide one of the Bed Frame Extension loops over the
bolt and hand-tighten with a nut (Figures 11 & 11a). Repeat with the other shorter bolt.
• Reaching underneath, insert the longest bolt into the lower hole and hand-tighten with a
nut.
• To fully tighten all three nuts to the bolts, insert the Allen Wrench into the bolt heads and
tighten the nuts using a 10/13mm Open-Ended Wrench.
Lower Portion
Upper Portion
Bed Frame Extension
11
STEP 3 Table Bed and Bed Frame Extension Assembly
FIGURE 10
FIGURE 9
Lower Hole / Longer Bolt
Upper Holes / Shorter Bolts
1
2
FIGURE 11
Bed Frame Extension Loop
2
Shorter Bolt
1
FIGURE 11a
