Teesa TSA8024, Owner'S Manual

Page: 16 / 44

EN
Owner’s manual 16
ASSEMBLY
1. Remove the rear guard screw from the motor shaft.
2. Position the rear guard against the front of the motor housing through the motor shaft.
Ensure that the handle at the rear guard is facing up and that all guiding pegs on the
motor housing are lined up with the cutouts on the rear guard.
3. Secure the read guard with the rear guard screw. Fasten it onto the motor housing by
tightening it in a clockwise direction.
4. Install the blade onto the motor shaft with the cutouts fitted.
5. Fasten it into place by tightening the blade screw counter-clockwise.
6. Attach the front plate to the front guard by tightening the screws.
7. Attach the front guard to the rear guard with the clamps.
8. Check the correct rotation of the blade.
BASE
BLADE AND GUARDS
FIG.1 FIG.2 FIG.3
1. Unscrew the bolt and
washer from the stand.
2. Insert the stand into the
base, attach the washer
and tighten the bolt.
3. Loosen the height
adjustment nut and
adjust the telescopic
tube to the desired
height.
NOTE: If you cannot see the
telescopic tube, it may has
slid inside the stand. If such
case pull it out from the
stand.