Teesa TSA2011, Owner'S Manua

Page: 26 / 72

Owner’s manual 26
EN
Iron does not steam The water tank may be empty. Unplug the iron from the mains
supply, turn the steam ruler to “0” and add water. Leave the iron
for few minutes to heat (depending on selected temperature), and
then set the steam dial to the steam setting.
Shot of steam
feature does not
work
The water tank must be filled up. Fill the iron as described in the
section “how to fill the water tank”. Steam must be on. Iron should
be in the horizontal position. Prime pump briefly. Make short
pauses between shots. Be sure you depress the burst of steam
button fully.
Spray mist feature
does not work
The water tank must be filled up. Fill the iron as described in the
section “how to fill the water tank”, and try again.
Iron is leaking The steam ruler must be set off, until the iron is hot. If the set
temperature is too low, the steam will not be produced, and the
iron will be leaking.
If the shots of steam are used too often, the iron won’t be able to
reheat, and won’t produce steam. Make pauses between shots of
steam.
SPECIFICATION
Main features
• Vertical ironing function
• Dry ironing function
• Auto shut-off:
- vertically: after 8 min.
- horizontally: after 30 sec.
• Handle covered with non-slip coating
• Temperature indicator
• Auto-off indicator
• Flexible cord swivel
• Low temperature anti-drip function
• Self-clean function
• Anti-calc system
• Spray
• Vertical steam boost
• Stable heel rest
• Large water inlet
Technical data
• Steam shot: 120 g
• Continuous steam control:
- 1st level: 8-18 g/min.
- ECO: 15-25 g/min.
- BOOST: 20-30 g/min.