2
WARNING!
Before installing and commissioning, please read these instructions
1. GENERAL
Commissioning and operation of the device can be made only after a careful reading of this handbook.
Due to the continuous development of technical equipment, some of its functions can be modified and operation may differ in detail from the description
in the manual. This is not a device error, but the result of continuous progress and modification work unit.
Damage from improper handling results in a loss of warranty. Any alteration of the rectifier are prohibited and void the warranty.
2. SAFETY
Staff operating the device should have the necessary qualifications entitling them to carry out welding work:
•
should have the competence in the field of electric welder MMA welding and gas-shielded,
•
know the rules of safety during the operation of the power they are welding equipment and auxiliary equipment powered by electricity,
•
know the safety rules when handling and installation of the cylinder of compressed gas (argon)
•
know the contents of this manual and use the device for its intended purpose.
WARNING
Welding may endanger the safety of the operator and other persons in the vicinity. Therefore, when welding special precautions must be
taken. Prior to welding, refer to the applicable health and safety regulations in the workplace. During electric welding MMA and TIG has the
following hazards:
•
ELECTRIC SHOCK
•
ARC NEGATIVE IMPACT ON HUMAN EYES AND SKIN
•
PAIRS AND GAS POISONING
•
BURNS
•
EXPLOSION AND FIRE HAZARDS
•
NOISE
Prevention of electric shock:
•
a device connected to a technically efficient electrical system in a proper security and effectiveness of neutral (additional fire protection); Check
and properly connect to the network and other devices in the workplace welder,
•
current leads off with the mounted unit,
•
It does not simultaneously touch the non-insulated part of the electrode holder, the electrode and the workpiece in the device housing,
•
Do not use the handles and load wires with damaged insulation,
•
under special hazard of electric shock (work in environments with high humidity and closed tanks) to work with the helper supporting the work of
the welder and watchful over the safety, use gloves and clothing with good insulation properties,
•
if you notice any irregularities, please contact the competent people to remove them,
•
It is forbidden to operate the device with the covers removed.
Preventing negative effects of electric arc on human skin and eyes:
•
Use protective clothing (gloves, lab coat, shoes, leather)
•
Use protective shields or helmets with properly matched filter,
•
Use protective curtains of non-combustible materials, and properly selected colors wall absorbing the harmful radiation.
