17
4. Align the hole in the brake pad lever to the hole in
the bracket with a small punch.
5. With the short side up, slide the control link through
the slotted hole of the control lever. Place opposite
end of link into slotted hole of brake pad lever short
side up.
6. Slide control link to its proper position in the control
lever.
7. Position control lever and pivot screw.
8. Tighten both pivot screws, and remove alignment
punch.
CAUTION:
Secure the screws with red Loctite. DO
NOT over torque or the brake pad will be distorted.
Then a new pad and lever assembly will be required.
9. Place large end of return spring in hole of control
lever, short end of spring on the notch in the brake
bracket.
10. Reposition shorting clip and attach grounding wire.
BRAKE BRACKET
BRAKE CONTROL
LEVER
SMALL END
LARGE END
RETURN
SPRING
ALIGNMENT PIN
CONTROL LINK
CONTROL LEVER
www.mymowerparts.com
For Discount Tecumseh Engine Parts Call 606-678-9623 or 606-561-4983
