Tecsun S-8800, Operation Manual

Page: 23 / 40

20
MW ATS
i) Turn on the radio, select VF mode and rotate the [BAND SELECT] knob or
press the [MW] button on the remote control to choose MW band.
ii) Press the [ATS] button on the radio or press and hold the [MW] button on the
remote control to activate the auto tuning storage function.
LW ATS
i) Turn on the radio, select VF mode and rotate the [BAND SELECT] knob or press
the [MW] button on the remote control twice to choose LW band.
ii) Press the [ATS] button on the radio or press and hold the [MW] button on the
remote control to activate the auto tuning storage function.
SW ATS
Mode A :
Follow the below steps to perform the ATS function within all meter bands.
i) Turn on the radio, select VF mode and rotate the [BAND SELECT] knob or press
the [SW-] or [SW+] button on the remote control to choose SW band.
ii) Press the [ATS] button on the radio, or press and hold the [SW-] button on the
remote control to activate the auto tuning storage function.
Mode B :
Follow the below steps to perform the ATS function within your selected SW meter
band.
i) Turn on the radio, select VF mode and rotate the [BAND SELECT] knob or
press the [SW-] or [SW+] button on the remote control to choose SW band.
ii) After selecting your desired SW meter band, press and hold the [SW+] button on
the remote control to activate the auto tuning storage function.
Note:
1. When using the ATS function for FM, LW, MW or SW mode A, previously stored
radio stations are automatically replaced by the newly found stations.
2. When using the ATS function in SW mode B, previously stored stations will not be
replaced; all newly found radio stations will be stored in blank memory locations.
3. If there is too much interference in your surroundings, or many mirror stations or
blank stations are stored during the ATS operation, extend the telescopic antenna
to enhance FM and SW reception, or rotate the radio for better reception of LW
and MW, because the built-in MW ferrite bar is directional. You may also try to
push the [DX / LOCAL] switch to [LOCAL] position to enhance ATS performance.
10
10
10