Tecsun S-8800, Operation Manual

Page: 17 / 40

14
Note:
When the memory contains no stored stations, it is not possible to switch
VF and VM mode; the device will automatically be in VF mode.
between
VF (View Frequency) & VM (View Memory) MODE
TUNING INTO STATIONS
Before tuning into FM or short wave stations, push the [INT ANT.] switch to the
proper position following the instructions about antenna usage as described in
section 8.
MANUAL TUNING
In VF (View Frequency) mode, rotate the [TUNING] knob to search for your
desired station. Alternatively, use the tuning options [ ], [ ], [ ], and [ ] on
the remote control.
VF (View Frequency):
Press the [VF/VM] button on the radio
or remote control . When the clock or
alarm time is shown in the upper right
corner of the display, the VF mode is
activated. If it shows the preset station
number, press the [VF/VM] button again.
View Frequency display
View Memory display
VM (View Memory):
Press the [VF/VM] button. When the
preset station number “P0XX” is shown
in the upper right corner of the display,
the VM mode is activated. If it shows the
clock or alarm time, press the [VF/VM]
button again.
AUTO SCAN TUNING
In VF mode, press and hold the [VF/VM] button on the radio or [SCAN] button
on the remote control. The scanning indicator “ ” advances from left to right while
the device automatically scans the available stations, staying on each station for
about 5 seconds. To stop the auto scan function, rotate the [TUNING] knob or
press the [SCAN] button on the remote control.
46