P. 3
| Tecshow Skytech 4000
English version
2. SAFETY INSTRUCTION
3. INSTALLATION INSTRUCTION
4. CONTROL METHOD
•
Inquiry a qualified maintainer before you main
-
tain the product.
•
Let the light power off before you install the
lamp or move the equipment.
•
Don’t use the different power voltage and dif
-
ferent kinds of lamp.
•
During use this light, it may generate high
temperature to cause danger. Please don’t put
• The optimal operation temperature is below
35ºC
•
The person who install, operate and maintain
this product must be familiar with the functions
of the light. Most of damage are conducted by
irregular operation.
• Please open and inspect the equipment when
use it at first time to find if there is any damage
caused by transportation
•
Before replace the lamp, please make sure the
power is off and the lamp is cold (the tempera
-
•
Check the screws at first
•
Fasten the light, set the scan switch to ON
position. This switch can control light scanning
(moving). Set this switch to OFF position, then
the light can not scan ( move).
• Make the power on.
• Adjust the light manually to control the beam
angle.
any inflammable or explosive material near the
equipment, don’t touch the light directly by
hand.
•
Make sure the distance of the equipment is over
5 meter.
• Don’t look at the lamp directly to avoid eyes
injury.
ture of the lamp could be over 400ºC)
•
Open the maintaining lid, then open the lamp
lid, replaces the lamp. In the meantime, please
don’t touch the lamp directly by hand
•
Cover the lamp lid and fasten the screws.
• Please install the light in a ventilate environ-
ment, Please check if the fan and fan gird are
blocked
•
Make yellow/green line safely connect with
ground
• Don’t shake the light when it is in use.
Design and product specifications are subject to
change without prior notice.
