P. 9
| Tecshow Quadbar 16 IP
Notice
1. When the product powers on and shows
version information, pressing the “MODE” and
“SETUP” buttons for some seconds at the same
time. After this,it can restore factory settings
and the data will be initialized.
2. If no press any button in 30s, it will lock screen
automatically and show current operating
mode, software version and temperature. Of
course, it will unlock again by pressing the
mode and setup button for 3s at the same time.
3. If there are following two sides, to make sure
the light can operate normally, please check
whether lines of internal temperature control
connect well.
•
When the product powers up, the LED dis
-
play screen shows temperature “×”.
•
After the product starts up and lock the
screen, it will show ×°C.
4.
In order to avoid any problem, please follow the
user manual to make sure it is in safety opera
-
tions.
5. If the environment temperature is not in the
using range, please reduce the using time of
the full power to prevent products damaged
because of overheating.
6.
In order to prevent the accident, please don’t
tear down the light under the condition of
charging.
English version
RESET_DEVICE
*
FACTORY_DEFAULTS
*
Design and product specifications are subject to change without prior notice.
