P. 12
Tecshow Navigator 3+ |
7. Press and hold down the Program button for
approximately 2 seconds or until the PROG
indicator in the LED display stops flashing. A
flashing Blackout indicator, in the LED display, is
indicative that you are out of program mode.
Delete A Chase
1. Press and hold down the Program button for
approximately 2 seconds or until the PROG
indicator in the LED display flashes. Once the
indicator is flashing, record mode is engaged
and you may release the Program button.
2. Select the Chase # button, 1-12, that you want
to delete.
3. Simultaneously, press the Auto/Del button then
press the same Chase # button that you select-
ed in step 2. All LED´s should flash three times
to confirm that the case was deleted.
4. Repeat steps 2 & 3 to delete additional scenes.
5.
Press and hold down the Program button for
approximately 2 seconds or until the PROG
indicator in the LED display stops flashing. A
flashing Blackout indicator, in the LED display, is
indicative that you are out of program mode.
Delete All Chases
1. Flip the Operators power switch OFF which is
located at the rear of the unit.
2. Simultaneously, press and hold down the Auto/
Del and Bank Down buttons and flip the power
switch ON. All LED´s will flash three times to
confirm that all chases were deleted.
15. CHASE PLAYBACK
Manual Trigger
1. When powered ON, this console defaults to
Manual/Blackout mode. All output will be in
a blackout state until the Blackout button is
deselected. To determine blackout status there
is an indicator light in the display that flashes
when engaged and OFF when disengaged.
Press the Blackout button so the indicator
stops flashing.
2. Press the Chase # button, 1-12, that you want
to playback. The selected chase LED should
illuminate.
3. Press the BANK UP & DOWN buttons, as desired,
to manual step through your chase steps. You
can also manually adjust the Fade Time fader
if you wish to incorporate a crossfade between
step.
4. Repeat steps 2 & 3 to manually playback addi-
tional chases.
Auto Trigger
1. Press the AUTO/Del button, the Auto Trigger
indicator light will illuminate in the LED display.
This indicates you that you are now in the Auto
trigger mode.
2. Press the Chase # button, 1-12, that you wish to
playback. The selected Chase LED should illu-
minate and begin to play. You can select more
than one chase # button at a time to create a
chase sequence.
3. At any time, you can adjust the Speed and Fade
fader to set your chase playback state. You can
also press the Tap/Disp button twice to estab-
lish a chase rate. The rate will be determined
by the tempo at which you press the Tap/Disp
button.
Audio Trigger
1. Press the Music/Rec button, the Audio Trigger
indicator light will illuminate in the LED display.
English version
