P. 10
Tecshow LycoZoom 50 |
English version
7. MAINTENANCE
• Make sure the area below the installation place
is free from unwanted persons during setup.
•
Switch off the unit, unplug the main cable and
wait until the unit has cooled down.
• All screws used for installing the device and
any of its parts should be tightly fastened and
should not be corroded.
•
Housing, fixations and installation spots (ceil
-
ing, trusses, suspensions) slound be totally free
from any deformation.
• The main cables must be in impeccable condi-
tion and should be replaced immediately even
1. Remove the safety cap by a screwdriver.
2.
Replace the blown fuse with a fuse to the exact same type and rating (T2A-250V)
3. Install the safety cap, and reconnect power.
when a small problem is detected.
• It is recommended to clean the front at regu-
lar internvals, from impurities caused by dust,
smoke, or other particles to ensure that the
light is radiated at maximum brightness. For
cleaning, disconnect the main plug from the
socket. Use a soft, clan cloth moistened with
a mild detergent. The carefullt wipe the part
dry. For cleaning other housing parts use only
a soft, clean cloth. Never use a liquid, it might
penetrate the unit and cause damage to it.
Maintenance and Cleaning The Unit
Fuse Replacement
