P. 6
Tecshow Halo 1R |
English version
System errors
If the red ERR indicator light light on, it means fixture running error, and enter
the sub-surface to check the details. Press “Clear” to empty the error record
after finish check. Note: Sometimes it not the installation problem of Hall or
optocoupler. It is because the motor cable inversely connect.
Total Fixture hours
Total using hour (accurate to minute)
Partial Fixture hours
The using hour from the power on (accurate to minute)
Total lamp hours
Total lighting hour (accurate to minute)
Partial lamp hours
This time lighting hour (accurate to minute)
Error information
Instruction
Reset fail, uart error
Driver board no respond. There is problem in the uart communication
line of display board and driver board. Or the driver board problem.
Pan reset fail
X photoelectric switch, or X Motor problem.
Tilt reset fail
Y photoelectric switch, or Y Motor problem.
Pan Hall error
Problem in X Hall.
Tilt Hall error
Problem in Y Hall.
Motor Colour reset fail
There is problem in Color wheel hall, or Color wheel motor.
Motor Gobo reset fail
There is problem in Gobo wheel hall, or Gobo wheel motor.
Lamp control fail
Lamp light on or off fail, there is problem in ballast or lamp.
lamp hours too long, pls replace
The total lamp light hour over the Maximum lamp light hour in “high
class” menu. Remind the user change the lamp in time. And then clear
the lamp light hour in “high class”, timer reset.
In hear to set a password, to prevent the non-spe
-
cialize person to faulty operate. Default password
is “UP DOWN UP DOWN”. Press “Enter” to verify the
password.
Advanced interface
Option
Instruction
Sensor Monitor
Tilt Hall state
0 means the magnet closure, 1 means the magnet stagger.
Color hall state
0 means the magnet closure, 1 means the magnet stagger.
Gobo hall state
0 means the magnet closure, 1 means the magnet stagger.
Pan codewheel state
2digit, each digit corresponding to the photoelectricity
switch on the coding disc.
Tilt codewheel state
2digit, each digit corresponding to the photoelectricity
switch on the coding disc.
Pan codewheel step
Running in positive direction, the step value adding, Run-
ning in negative direction, the step value reduced.
Tilt codewheel step
Running in positive direction, the step value adding, Run-
ning in negative direction, the step value reduced.
