ALARM
Alarm is the state of your security system when a device has been activated by a breach
of security.
When an alarm occurs an area light will flash to indicate which area the alarm is coming
from.
To determine the cause of the alarm:
<ENTER>
<ENTER> The
inputs
causing
the alarm are listed.
And
<NEXT>
Update the list of inputs in alarm and display the next
Input(s) in the list (if any).
Or
0 <ENTER>
Stop cameras operating and return to the initial display
Showing Code: etc.
Or
? <ENTER>
Display the input name in full.
Reset an Alarm:
(The bottom line of the display must show “Code:”)
1 2 3 4 (Your PIN) <ENTER>
If Areas are displayed after entering the code as above
:
? (Area number) <ENTER>
If the reset function is successful:
-
The area light stops flashing and returns to the state it was in before the
alarm occurred.
-
The display will show, “There Are No Alarms In This Area”.
Notes:
1. If the alarm conditions are no longer valid (false alarm), and the alarm
has been reset, it is important that you contact your monitoring
company to ensure that no further action is taken by them.
2. If you are unable to reset an alarm because of a faulty input, refer to
“Isolate Input”.
3. You can only reset an alarm for an area which is assigned to your PIN.