TECO TWW16CFDG, User Manual, Page: 8 / 23

Installa on
Teco Australia Pty Ltd will not warrant the equipment supplied, if the installa�on does not comply with
the Building Code of Australia or any Local Government standard or code. The customer/contractor is solely
responsible for ensuring that the equipment installed complies with all relevant building codes or standards.
IMPORTANT NOTICE
CAUTION
Due to various wall and window types and construc ons, Teco Australia Pty Ltd recommends the window/wall
type room air condi oner must be installed with compliance to the Building Code of Australia, Local Government
or body corporate requirements. Please consult your local builder or air condi oning contractor.
All hardware required to install the air condi oner is fi eld supplied.
Drainage
8
the condenser coil during opera�on. Draining water away from the base may cause a slight loss in
performance.
1. Thermosta�cally controlled drain mechanism. The drain will open <14 C (approx.) to allow water
to drain from the base and will close >15 C (approx.).
2. Drain hole with rubber plug fi�ed
The Cooling model has only one drain hole with rubber plug fi � ed.
Please remove the rubber plug fi�ed to the drain hole if the noise of splashing water bothers you or if
the water droplets splashed through the condenser coil drops to the ground below causes a trip hazard
or during Winter to release defrosted water quickly from the base.
To install a drain line please follow the steps below:
1. Slide out the chassis from the cabinet.
2. Remove the rubber plug from the body base plate.
3. Install the drain pan to the corner of the cabinet with 2 screws.
4. Slide the chassis into its original place in the cabinet.
5. Connect the drain hose (field supplied) to the outlet on the drain pan bo�om.
WARNING: Do not push any object into the condensate drain hole as it may damage the condensa�on
water thermostat mounted above.
Drain Hole s
Drain Plug
The cooling and heating model has two drain holes:
( For illustration
purposes only )