TECO TWM50FA, User Manual

Page: 7 / 18

6
Installing the Drain Hose
When placing the drain hose, ensure it is above 600mm and below 1000mm.
Otherwise, the washer may not drain correctly and an error will occur. Ensure
the drain hose is placed in a drain with a diameter of at least 30mm to meet
minimum drainage fl ow requirements. Secure the drain hose in place to avoid
leaking and spilling as the water drains. Do not immerse the drain hose in
water.
Installing the water inlet hose
1. Fasten one end of the inlet hose to
the tap. Ensure there is a rubber
washer inside the hose before
fastening. The washer prevents water
leakage.
2. Securely tighten the other end of the inlet hose to the clothes washer inlet
valve. Ensure the rubber washer is inside the hose before tightening.
3. When tightening the clamping nut, apply even pressure. Do not apply too
much force or twist the valve as this may damage or break the valve joint.
PLEASE NOTE
Be sure to install the inlet hose to COLD water only. Incorrect installation can
reduce performance or damage the clothes washer.
Sink / Basin
Secure in
place here
Drain at least 30mm
diameter
Bind
Max.1000
Min.600mm
Min.60
0m
m
Max.100
0m
m
mm