TECO TWM50FA, User Manual

Page: 14 / 18

13
TROUBLESHOOTING
If the clothes washer does not perform as expected, malfunctions or an alarm
is sounding, please check the following list of possible solutions.
If a solution can not be found or the problem persists, please contact TECO
service (refer to
Page 16 ).
Do not, under any circumstance, dismantle the appliance.
LIST OF FAULTS AND POSSIBLE SOLUTIONS
FAULT POSSIBLE SOLUTION
No water is fl owing in

Check the power source is ON

Check if the circuit breaker has been triggered
or fuse is not burnt out
 Check the water supply is in the open position
and the water pressure reaches the minimum
required by the washer

Check the inlet hose has been installed
correctly
 Check the fi lter of the inlet valve is not
blocked or obstructed

Check if the START / PAUSE button has been
pressed
Not washing  Check the power is on and the circuit breaker
has not been tripped or the fuse burnt out

If the minimum water level is not reached

Check if delay start has been set
Not draining  Check the drain hose is not too high
 Check the drain hose is not obstructed

Check the drain valve is not obstructed
Abnormal or not spinning  Check the door is completely closed
 Check that the laundry does not exceed the
rated capacity

Check the clothes washer is level

The motor belt may be loose
Please check the points below after maintenance:
 Is there any damage to the power lead?
 Can the power plug be inserted into the socket correctly?

Is the power plug and/or lead heating up?

Do the fi lters need cleaning?