18
AQUA-STOP HOSE
DISCONNECTING THE AQUA-STOP HOSE
COLD WATER CONNECTION
DRAIN HOSE CONNECTION
The Aqua-stop hose consists of double walls. The hose system guarantees its intervention
by blocking the
fl
ow of water in cases where the supply hose breaks or when the space
between the supply hose itself and the outer corrugated hose is full of water.
Connect the cold water supply hose to a threaded 19mm (3/4 inch) connector and make
sure that it is fastened tightly in place. If the water pipes are new or have not been used for
an extended period of time, let the water run, to make sure that the water is clear and free
of impurities. This is done to prevent the water inlet from blockages and damage to the
dishwasher.
Insert the drain hose into a drain pipe with a minimum diameter of 40mm, or let it run into
the sink, making sure to avoid bending or crimping it. The hose must not be raised above
1m.
Choose either method A or B (refer to Fig.19) to connect the drain hose.
Turn off the water at the source.
Release the water pressure by depressing the hose slightly.
Unscrew the Aqua-stop hose from the faucet.
Step 1
Step 2
Step 3
Fig.17
A
Sink
Front
Drain pipe
NOTE
The top of the hose
must be less than
1m.
B
