TECO FM50101-X, Instructions & User'S Manual

Page: 5 / 68

1. Safety Precautions
5
FLUXMASTER 50 INSTRUCTION MANUAL
1.1 Precautions For Operation Before Turning On Power
CAUTION
Choose the appropriate power source with correct voltage settings for the input voltage specification of the AC drive.
WARNING
Special care must be taken while wiring the primary circuitry panel.The L1 and L2 terminal must be connected to the input
power source and must not be mistakenly connected to T1, T2 or T3 output terminals.This may damage the AC drive when
the power is turned on.
CAUTION
❙
Do not attempt to transport the FM50 by the front of the cover. Securely hold AC Drives by the heat-sink mounting
chassis to prevent it from falling.This may cause personal injury or damage to the AC drive.
❙
Install the drive onto a firm metal base plate or another non-flammable type material. Do not install the drive on or
near any flammable material.
❙
An additional cooling fan may need to be installed if several drives are installed on one control panel.The temperature
inside an enclosed panel should be below 40 ˚C (104 ˚F) to avoid overheating.
❙
Turn off the power supply before proceeding to remove or perform any work on any panel. Carry out installation
procedures according to instructions given.This will help avoid a situation resulting in an operational malfunction.
❙
The AC Drive is suitable for use on a circuit capable of delivering not more than 5000 RMS symmetrical amperes.
❙
This product is not provided with overspeed protection.
❙
This product is only intended for use in a clean, dust and moisture free environment.