ENGLISH
UPS EVO DSP PLUS TM
3
User’s manual
2
General Characteristics
UPS EVO DSP PLUS TM has all the advanced features, which guarantee maximum reliability and safety:
•
Double-Conversion ON-LINE Transformerless technology
•
Sinusoidal wave generated by an IGBT Inverter
•
Output Voltage regulation
±
1%
•
Protection from overload and short circuits
•
Automatic Bypass to protect from accidental overload or Inverter fault
•
Start-up even under Mains OFF conditions
•
Automatic protection when Battery is low
•
Automatic restart, following an automatic shut-down due to Low Battery, once AC utility power comes
back on
•
Selectable Input Frequency (50/60 Hz)
•
Graphic LCD panel for visualization of the Input and Output Voltage measurements, batteries Voltage,
percentage of load, Frequency, alarms, overload, fault and path of energy flow
•
Acoustic signals of various kinds indicating alarm situations
•
Available settings of all the UPS parameters by user through front panel pushbuttons and graphic LCD
panel
•
SNMP Adapter (optional)
•
EPO (Emergency Power OFF)
•
Communication with the computer through RS-232 and USB interfaces
•
Available extended autonomy by adding external Battery Boxes
•
Manual Bypass for maintenance
•
Parallel operating mode up to 3 UPS’s (optional)
•
ECO functioning mode (selectable)
•
Frequency Converter functioning mode (selectable)
•
High efficiency
•
Maximum reliability
•
Smart design and easy to use
3
Receipt and site selection
Carefully remove the UPS from its packaging, and carry out a meticulous inspection. We recommend keeping the
original packaging in a secure place, in case you need to send the UPS for maintenance purposes. In case of
transport damage, notify the carrier and dealer immediately.
We recommend paying attention to the below points in order to choose a correct placement for your UPS:
•
The UPS is designed to operate in a protected environment (e.g. offices). We therefore recommend
installing it in a place with very little or no humidity, dust or smoke.
•
When the UPS is brought from a cold place to a warmer place, humidity in the air may cause condensation
in the UPS. In this case, allow UPS to stand for two hours in the warmer place before beginning with the
installation.