TECNOVAP AIDA BABY, Using Instruction

Page: 18 / 24

AIDA BABY
18 TECNOVAP REV.0
– 10/2010
Triangular brush (118): Adapted for the cleaning of armchairs, sofas, and mattresses we
suggest to use the triangular brush with a cloth fastened with a special clamp.
rectangular brush (117):
For tiled floors: To carry out specific grout cleaning we suggest that you use the steam
lance (119) with the small brush (120 or 125 according to the need). In this way it will be
possible to dislodge the most difficult dirt and remove it from the groust using the applied
pressure. To remove the dirt from the floor use the rectangular brush (117) wrapped in a
cloth, which will work as an “extractor” when fastened with the special clamps. We suggest
applying steam also while picking up the dirty water. To get a good result, work with
surface areas not larger than 5m² thus preventing dirt from drying and adhering on the
floor again. We suggest that you use the brush without the cloth when the dirt to be
disloged is considerable; and when the dirt is not considerable, it is enougth to work with
the brush wrapped in cloth.
When confronted with solid objects while cleaning the floor (i.e. chewing-gum) use the
special scraper (124) which can be attached to the steam lance (119) and is able to
remove stubborn objects without scratching the work surface.
To remove wax from the floor use a cloth fastened to the rectangular brush.The steam
helps loosen the wax so that its removal will be easier . To spread the wax on the floor use
as mentioned above a clean cloth fastened on the brush (117). Put the wax on the cloth,
the heat of the steam will help spread the wax evenly so that its penetration will be eassier
in also this case. When the wax is dry proceed with normal buffing methods.
Only the power of steam is able to replace all types of chemical products.
WARNING
THE GENERATOR PRODUCES STEAM WITH A TEMPERATURE OVER 100° C.
BEFORE STARTING THE CLEANING TASK WE SUGGEST TO TRY ON A SMALL
AREA TO AVOID DAMAGES.
Marble and parquet floor: We suggest adding a cotton cloth wrapped on the brush (117),
to avoid scratching the surface. To continue the cleaning it is necessary to charge the cloth
according to the quanity of dirt to be collected on the floor.
WARNING
THE STEAM SHOULD NOT BE IN DIRECT CONTACT WITH THE FLOOR FOR AN
EXTENDED PERIOD OF TIME. SUCH SURFACES MAY BE DAMAGED IN CASE OF
COMBINED USE OF EXCESSIVE HEAT, HUMIDITY AND BRISTLES. THEREFORE
CARRY OUT THE TASK IN THE SHORTEST POSSIBLE TIME.