How to use
SECU-EYE operation
1.
Check the SD memory card properly inserted into the system body.
2.
Turn on the engine.
3.
If the setup file is not on the SD memory card, the LED will be blinked and will start the
setup process.
- Start to create the setup file.
- After creating the setup file, start to adjust the X,Y,Z default value of GPS.
This process may take about one minute.
- A few seconds after adjusting the GPS default value, the voice command will be started
and start to record the video in general mode.
4.
If the setup file is on the SD memory card, the voice command will be started after a few
seconds and start to record the video in general mode.
5.
Receiving the GPS signal, the GPS LED will be blinked.
6.
If the G-sensor detects the more than a certain level impact during the driving, it will save
the event record.
7.
If the driver pushes the Emergency button during the driving, it will save the manual
record.
8.
(In case of using Cigar jack only) when turn off the engine, the “safe back home” mode
will be started after a few seconds and run for one minute with voice command.
- If the Cigar jack is disconnected the POWER LED will be blinking in blue color.
- If the Cigar jack is connected, POWER LED will be blinking in red color.
Voice command : “Change to Parking Mode”
9.
(In case of using Cigar jack) after completing the “safe back home” mode, the “Parking
mode” will be started and save the video record during preset parking time.
