TECNOMAGNETE MaxX 1000, Use And Maintenance Manual

Page: 14 / 26

14
codice 09MAXX001
versione EN
revisione 01
Use and Maintenance Manual
MaxX
TE CN OM A GN ETE Sp A
Via N er v iano , 31
M ade in ITA LY
200 20 - Laina te (M i)
D D
D D
H
G
C
A
F
E
E
C
B
F
G
H
I I
I
I
6 GENERAL DESCRIPTION
OF THE SUPPLY
6.1
MaxX
description of the supply
Tecnomagnete's products and methods conform to the
European Union directive governing the reduction of
harmful substances (RoHS). MaxX is composed by:

Eyebolt (only for MaxX125) or Load ringmade of
galvanized steel
 Structure/body in nickel-plated steel
 Side covers made of aluminium with polyurethane
enamel varnish (see paragraph 4.1 with yellow colour
RAL1003 for the models shown in Fig. 4.1 A or red
RAL3000 for the models shown in Fig. 4.1 b)

Aluminium plates with laser serigraphy

Galvanized steel lever with plastic handle

amagnetic steel lever locking pin
fixing screws and grain for fastening the lever made of
galvanized steel
Fig.6.1A
Fig.6.1B
Description
Customized Eyebolt to design TECNOMAGNETE
Ⓐ
Customized Load ring to design TECNOMAGNETE
Ⓑ
Structure / body
Ⓒ
Side covers
Ⓓ
Label
Ⓔ
Lever and handle
Ⓕ
Pin lever (for lever lock)
Ⓖ
Grain (for lever fixing)
Ⓗ
Fixing screws
Ⓘ
7 INSTALLATION
7.1
Generic installation
The models MaxX125, MaxX250, MaxX300E, MaxX500,
MaxX600E, MaxXTG150 and MaxXTG300 are pre-
assembled manual lifters which do not require any further
installation by the user, for which they mean "ready to
use" products. Only for the above models you can proceed
first with phase a) and then with phase H).
For the models MaxX1000, MaxX1500 and MaxX2000 the
commissioning is extremely easy as long as the following
procedure is carefully followed:
a) pay attention to the weight of the MaxX model
(see paragraph 5.2 table Fig. 5.2B) and then lift it
up (see paragraph 2.2) by means of an appropriate
lifting body and move it by hooking it up from the
eyebolt / load ring:
Fig.7.1A
b) Lay MaxX on an iron plate lying on the ground or
on a support suitable for the weights of both the
plate and MaxX.
The iron plate shall have a minimum thickness as
indicated in sub-paragraph 3.2.4 Fig. 3.2.4A and
Fig. 3.2.4B.
Fig.7.1B
c) Arrange the lever, the fastening grain and the tool
for assembly
Fig.7.1C
EXAMPLE
Grain
Lever
Tool