Reversing the door
This refrigerator has been built with the door hinges on the right. If you wish to
change the opening direction, follow the instructions below:
1. Remove the upper hinge cover (6) first.
2. Remove the two screws (1) that hold the upper hinge (5) (right side) to the fridge
body. Remove the upper hinge (5).
3. Lift the door and place it on a padded surface to prevent scratching it.
4. Reverse the hole cover plate (7) from the left side to the right.
5. Remove the foot (3) and the two screws (8) that hold the lower hinge (2) and
remove the lower hinge (2).
6. Remove the left front foot (4) and transfer it to the right side.
7. Before fitting the lower hinge (2), swap over the hinge pin (9) to the other side of
the lower hinge (2). Then install the lower hinge (2) onto the left side of the lower
frame with two screws (8), then re-fit the foot(3).
8. Position the door in place making sure the door seats onto the lower hinge (2).
9. Align the door in the closed position secure the upper hinge (5) in the top fame on
left side with two screws (1). Remember, do not tighten the two screws (1) until
the top of the door is leveled with the top of the fridge.
10. Install the upper hinge cover (6) on the upper hinge.
FIGURE 1 - REPRESENTATIVE POSITION OF COMPONENTS PRIOR TO
DOOR REVERSAL.
FIGURE 2 - R
EPR
ESENTATIVE POSITION OF COMPONENTS AFTER
DOOR REVERSAL.
7
