4
given supervision or instruction concerning use of the appliance by a person responsible for
their safety.
Children should be supervised to ensure that they do not play on or near the appliance.
This appliance is for refrigerating food only.
REFRIGERANT
The refrigerating gas contained in the circuit of this appliance is Isobut
a
ne (R600a); it causes
a low level of pollution but is inflammable.
CAUTION
:
Extreme caution must be used when moving the appliance.
WARNINGS:
Do not damage the refrigerant circuit.
Do not use electrical appliances inside the food storage compartments of the
appliance, unless they are of the type recommended by the manufacturer.
If the appliance is installed in a carpeted area, do not let the carpet block the
ventilation holes in the base of the unit, adjust the levelling feet after a few hours to
compensate for carpet movement.
Keep ventilation openings, in the appliance enclosure or the built in structure clear of
obstructions.
Installation
Position the appliance and allow to stand for two to three hours before it is turned on
for the first time to allow the system to settle. Do not position next to any heat source
e.g. cooker, boiler or in direct sunlight etc.
A clearance of 10 cm must be left between the sides of the appliance and any adjacent
cabinets or walls to allow for adequate air circulation. The appliance is not designed for
recessed installation (“building in”).
Install on a good firm level surface, and any unevenness of the floor should be
corrected prior to installation, slight unevenness can be overcome by adjusting the
front feet.
Do not keep your appliance in a room where the temperature is likely to fall below 16
degrees C (61 degrees F) at night and/or especially in winter, as it is designed to
operate in ambient temperatures b16 and +32 degrees C (61 and 90 degrees
F). At lower temperatures the appliance may not operate, resulting in a reduction in
the storage life of the food.
Do not place the appliance near cookers or radiators or in direct sunlight, as this will cause
extra strain on the appliance’s functions.
If installed next to a source of heat such as a fridge, maintain the following minimum
clearances.
Choose a well-ventilated location with no less than 10cm clearance around the refrigerator.
Place the refrigerator in a location with a firm base in order to prevent vibration and excessive
noise.
Level the refrigerator by adjusting the two front feet.
