5
GB
IE
Starting up
Ignition of the burner
• Turn the knob from the "
●
" position to the maximum
flame position and keep it pushed. At the same
time repeatedly push the ignition button "
*
" until
the burner is ignited (see figs. 2 and 4).
• To obtain the minimum flame, further turn the knob
until it reaches the minimum flame position.
Note:
if the piezoelectric device cannot be used,
ignition may be made manually using a match or a
gas lighter.
Turning the unit off
To turn the burner off
• Turn the knob from the maximum or minimum flame
position until it reaches the “
●
” position.
Cleaning and taking care of the unit
Note
: The unit must be cold to clean it.
Empty the oil collection tray each day before
igniting the appliance.
Remember that a clean unit will work properly and
for a very long time.
The parts that can be removed are to be washed
separately using hot water and detergent. Rinse un-
der running water.
Do not use harsh or abrasive detergents to clean
the stainless steel parts. Iron cleaning pads should not
be used as they cause the formation of rust. For the
same reason, avoid contact with ferrous materials.
Do not use sand paper or sanded cloth to clean the
unit; in their place, and only under particular circum-
stances, use powdered pumice; in the case of stub-
born dirt a sponge might help (e.g. Scotch) or even
oven and grill spray products that are readily avail-
able on the market. If spray products are used follow
the manufacturer’s instructions.
What to do in case of a fault
If there is a malfunction, despite the fact you are
using the unit correctly, the gas supply is correct and
the components are clean and efficient, turn the unit
What to do if the unit is not going to be used for a long time
off immediately, stop the gas supply by turning the
upstream cock off, and call the assistance service.
Clean the unit thoroughly following the instructions
The Manufacturer declines any responsibility for damage caused by improper or incor-
rect installation or maintenance of the appliance, or failure to observe safety regulations!
and dry it carefully. Turn off the gas cutoff cock in-
stalled upstream.