_ TECNOEKA Srl _________________________________________________________ use and instruction
manual _
_ page 10
________________________________________________________________________________________
_
humidity
Power cable diameter
3x1,5 mm
²
Type of cable
H07RN-F
The noise level of the appliance in operation is below 70 dB (A).
The "technical data" plate is positioned on the rear panel of the appliance.
4. Instructions for the installer
The following instructions are aimed at the qualified installer, to ensure that he carries out
the installation, adjustment and maintenance operations as correctly as possible and
according to current legal regulations. Any operation must be performed with electrical power
cut to the appliance.
Before using the appliance, carefully remove the special adhesive film protecting the parts
in stainless steel. Do not leave any glue residues on the surfaces. If necessary, remove them
at once, with an appropriate solvent.
Fitting the feet
- The feet are inside the appliance and must be secured on the four
threaded holes on the base. If necessary, the height of the feet can be adjusted by screwing
or unscrewing.
Positioning
- Position the appliance perfectly horizontally on a table or similar support
(the table or support must be at least 85 cm above the floor). Position it at a distance of not
less than 10 cm from the side and rear walls, to enable natural ventilating air to circulate
freely around it. The appliance is ventilated through specific openings on the metal walls of
the outer housing , and ensures efficiency and long-life. For this reason it is strictly forbidden
to obstruct these ventilation openings, even partially or for short periods.
Failure to observe
this specific prohibition releases the manufacturer of the appliance from all
responsibility and immediately voids any guarantee rights for the said appliance,
because its constructive conformity has been voluntarily compromised. Furthermore, the
appliance is not suitable for embedding and for grouped positioning with other identical
appliances.
Electrical connection
- The appliance must be connected to the electrical mains
according to current legal regulations. Before making the connection, make sure of the
following:
- the voltage and frequency values of the power supply system match the values on the
"technical data" plate affixed on the appliance;
- the limiting valve and the system are able to support the appliance's load (see the
"technical data" plate);
-
the power supply system has an adequate earth connection according to
current legal regulations;
- a single-pole switch with minimum between-contacts aperture of 3 mm, sized to the
load and conforming to current legal regulations, is fitted between the appliance and
the mains in the direct connection to the mains;
- the single-pole switch used for connection is easy to reach when the appliance is
installed;
-
the yellow/green earth wire is not interrupted by the switch;