7
NOTE: this intended use is not subject to assessment by the Notified Body.
5. ROOM TEMPERATURE
When the thermometer is in stand-by mode (“Peak Performance” - see par. #4.1 and
#7), the room temperature remains displayed automatically for 4 hours after the last
reading is taken and the symbol flashes.
To display the room temperature when the display is off, press the “Mem” button
once: the display shows the room temperature and the symbol flashing.
6. MEMORY FUNCTION
The «Mem” button lets you call up the last 9 temperature readings.
To activate this function, press the “Mem” button
twice
: the value of the last rea-
ding will be shown accompanied by the number 1 and the symbol
or depending
on which button was used for that reading.
Pressing the button again calls up the second to last, third to last reading and so on,
accompanied by the numbers 2, 3, etc.
7. HOW TO CHANGE the SETTINGS
Depending on where it is to be sold, your thermometer leaves the factory as follows:
• preset to Celsius (°C) or Fahrenheit (°F)
• referred to oral (“ORAL”) or rectal (“RECTAL”) or axillary (“AX.”) or internal tempera-
ture readings (“CorE”) or only internal temperature readings (no symbol will be shown);
• with display off when in stand-by mode (“Energy Saving”, off ) or always on
(“Peak Performance” - on ).
If necessary, these settings can be modified as follows:
1. while the thermometer is off or in stand-by mode, press the “Mem” button and
hold it down; after about 8 seconds the visualization on the display changes showing
in rotation the following combinations:
2. When the new desired setting appears, release the button. Only one setting can be
modified at a time.
Note: