Tecnet TJ-3100, Service Manual

Page: 12 / 24

12
Sub-Tone channel LCD digit will be blinking
Press Up or DOWN to select your desired channel (1~38), and press Enter ( ) button to
confirm it.
To exit from menu, press M button or PTT switch.
Use same method to set up DCS ( ) or DCS Invertor ( ) Sub-Tone Channels
6.8.1 VOX Function On/Off selection:
Press Menu (P) button for more than 1 second and the radio will enter into function setting mode.
Press Menu (P) button again. Then VOX setting Icons will be blinking.
By pressing UP (
▲
) or DOWN (
▼
) button, you can select on or off. To exit from menu, press M
button or PTT switch.
6.8.2 Scan On/Off selection:
Press Menu (P) button for more than 1 second and the radio will enter into function setting mode.
Press Menu (P) button 2 times. Radio will go to Scan setting menu mode.
By pressing UP (
▲
) or DOWN (
▼
) button, you can select On or Off.
Select on and press Enter ( ) button to confirm Scan On. To exit from menu, Press M button or PTT
switch
If you want to enable Scan function, Press Menu (P) + Enter ( ) at the same time.
Then radio will begin scan. To stop Scan, press Menu (P) button.
( With programming software, a more selective type of scan method can be chosen.)
6.8.3 Beep Tone On/Off selection:
Press Menu (P) button for more than 1 second and the radio will enter into function setting mode.
Press Menu (P) button 3 times. Radio will go to Beep tone on/off setup mode.