![Tecnam P92 Eaglet Flight Manual Download Page 55](http://html.mh-extra.com/html/tecnam/p92-eaglet/p92-eaglet_flight-manual_1071524055.webp)
P92 Eaglet
Flight Manual
Revision Date: 12-14-2007
Revision Number: 1.00
Doc n° 27-13-100-00
55
SECTION 6
NORMAL PROCEDURES
6 Introduction
Section 6 contains checklists and the procedures for normal operation.
6.1 Removing and Reinstalling the Engine Cowling
6.1.1
Upper Cowling
Parking brake: .................................ON or chocks installed
Fuel selector valves: ........................OFF
Ignition Switches:............................OFF
Master switch: .................................OFF
•
Unlatch all four butterfly Cam-locks mounted on the top cowling by rotating them 90° counter clockwise while
slightly pushing inwards.
•
Remove the four screws holding the top canopy to the bottom.
•
Remove top engine cowling paying attention to propeller shaft passing through nose.
To reinstall:
•
Rest cowling horizontal insuring proper fitting of nose base reference pins.
•
Reinstall the four screws.
•
Secure latches by applying light pressure, check for proper assembly and fasten Cam-locks.
WARNING
Butterfly Cam-locks are locked when tabs are horizontal and open when tabs are vertical. Verify tab is below latch upon
closing.
6.1.2
Lower Cowling
After disassembling upper cowling
•
Move the propeller to a horizontal position
•
Using a standard screwdriver, press and rotate 90° the two Cam-locks positioned on lower cowling by the firewall.
•
Disconnect the ram-air duct from the NACA intake. Pull out the first hinge pin positioned on the side of the
firewall, then, while holding cowling, pull out second hinge pin; remove cowling with downward motion.
For installation follow reverse procedure