TECNA TE 500, User Manual

Page: 7 / 52

7 / 52
The programming parameters of the control unit are divided into different menus as shown in the
drawing above:
_
PROGRAMMING
_
CONFIGURATION
_
STEPPER
_
INSTALLATION
_
PROGRAM COPYING
_
INPUT CHECK
_
PROGRAM SEQUENCES
To begin the programming operations, turn the key in the PROG position and be aware of some of the
fundamental features of the control unit.
Arrow ">" on the left-hand side of the display indicates the cursor’s position.
Use keys
d
and
f
to move the cursor up and down whereas keys
h
and
g
are used for entering and
exiting from the menu selected by the cursor.
Use keys
a
and
s
to set the value of the parameter indicated by the cursor.
PROGRAMMING MENU
The "Programming" menu contains all the parameters associated with the welding cycle, the times and
the currents by means of which to carry out the welding process.
CONTROL UNIT PROGRAMMING
TE500 VER. 2.31
> PROGRAM DATA
SETUP MENU
STEPPER MENU
The first choice to make is the number of the program to be used. Choose among the 63 storable
programs using the
a
and
s
keys.
Then proceed with the next parameters moving with the
d
and
f
keys, adjusting the desired value
always using the
a
and
s
keys.
As such all the parameters will be set to the desired value for carrying out the welding process. Keep in
mind that there is no need to confirm the set data item that is stored automatically after the adjustment.
Parameters can have several values, according to the type of parameter. The minimum and maximum
limits of each parameter are shown in the following table.
PROGRAM DATA
>
PROGRAM NUMBER 01
WORK MODE IK
CONTROL MODE CUR