1
BATTERYMATE 150-9
Instructions for use:
IMPORTANT: Read the whole of this text before using the
BatteryMate.
MOUNTING BRACKET
A mounting bracket is included for fixing against a vertical surface so as to allow the
BatteryMate to be positioned off the workbench. Ensure that the bracket is firmly fixed so
that the surface of the long arm projects horizontally and safely supports a downward
force of 10 kg applied at the projecting end. Screws supplied with brackets should be
used for securely attaching the charger to the bracket through the smaller of the holes in
the longer bracket arm, when the charger is correctly located on the bracket.
NOTE
:
Mount the bracket in a position that allows batteries to he charged to be distanced
as far as possible from th e BatteryMate & NOT
directly above or below it.
CAUTION
This device is provided with an input voltage selector in the fuse drawer at the appliance
power cord inlet receptacle. The voltage for which the selector is set is displayed in an
aperture on the fuse drawer, which is located just above the power cord inlet receptacle.
Rated mains input voltages of 230, 115 or 100 Volts can be selected. Normally the
voltage for which the BatteryMate is set up should conform with the national standard
mains voltage of the country of purchase.
IT IS ESSENTIAL TO VERIFY THAT THE VOLTAGE DISPLAYED IN THE FUSE
DRAWER APERTURE CORRESPONDS WITH THE ACTUAL SUPPLY VOLTAGE. IF
NOT, THEN PROCEED AS FOLLOWS:
Disconnect the power cord and remove from the device. With a miniature screwdriver or
similar tool, prise open the fuse drawer. Then remove the pale coloured insert on which
the voltage selections are printed, rotate and replace it so that the correct input voltage
is visible through the aperture. Replace the fuse drawer. Make sure it is closed. If a fuse
blows, replace only with the same fuse type and rating as the original fuse.
WARNING!
Batteries emit
EXPLOSIVE GASES – prevent flames or sparks near batteries.
DO NOT PLACE BATTERIES UNDER CHARGE DIRECTLY ABOVE OR BELOW THE
BatteryMate.
Distance the battery from the
BatteryMate
as far as practicable. PROTECT
THE
BatteryMate
FROM DAMP & HUMIDITY & FROM ACID CONTAMINATION BOTH
DURING USE & DURING STORAGE.
NOTE :
Disconnect AC power supply before making or breaking battery connections.
Battery acid is highly corrosive. Wear protective clothing and avoid contact. In case of
accidental contact wash immediately with soap and water. Check that the battery posts
are not loose. If they are, have the battery professionally assessed. If the battery posts
are corroded clean with a copper wire brush; if greasy or dirty, clean with a rag damped
in detergent. Only use the
BatteryMate
if the input & output leads and clamps are in
good, undamaged condition.
Failure to observe the above warnings voids all
warranty.
Summary of Contents for BatteryMate 150-9
Page 1: ...BatteryMate 150 9 ...
