14
Before you start steam cleaning your floors, make sure:
1. The surfaces to be steam cleaned have been swept or vacuumed.
2. The steam mop is fully assembled (see Assembling paragraph).
3. The microfiber cloth sits tightly around the steam head.
(Do not use the mop without the microfiber cloth!)
4. The water tank is filled.
(Do not add cleaning solution, only use tap water, or distilled/purified water.)
USE
•
Unroll the power cord completely.
•
Check that the tension in force in the country where you are, corresponds to that
indicated on the apparatus.
•
Connect the apparatus in a correct socket-outlet, (and connected to the ground if
the unit is Class I), to avoid any danger.
•
Disconnect the power source cable before any operation of cleaning of
maintenance and accessories assembly.
•
Never modify the appliance in anyway.
Turn on the power switch, power indicator Light, the unit starts heating.
NOTE : It takes approximately 30 seconds for the unit to heat up and the steam to
be ready.
Push the unit along the floor, Forward and backward.
When the water level in the water tank is low, Turn off the power switch
immediately.
Unplug the unit from the electrical outlet and refill the water tank following the
Instructions.
NOTE : If you use steam mop for a long time, the cloth sleeve may become very
wet or dirty & will need to be replaced.
Turn off the unit & allow to cool before replacing.
NOTE : While replacing cloth sleeve don't touch steam head to avoid scalding.
To sanitize a specific area of your floor, position the steam mop over the area for a
minimum of 8 seconds, but no longer than 15 seconds.
NOTE : The steam temperature will reach approximately 90-110°C. This is
particularly useful for cleaning bathroom, shower, pet sleeping area or around
garbage bins.
WARNING
Never run the steam mop without water.
Never direct steam at any person or animal.
