10
3)
Once the unit has been fully assembled and filled with water, plug in the Power
Cord to a grounded electrical outlet. Power Switch (O/ I) is in the OFF(O) position,
turns the Power Switch (O/ I) to the ON(I) position. Approximately 20 seconds,the
Mop will start emitting steam. Adjust the steam regulator and choose the
approximate steam output amount according to your requirement..
To stop emitting steam, turns the Power Switch (O/ I) to the OFF(O) position.
It is normal that a little water maybe ejected from nozzle before steam starts
4)
Slowly pass over the surface to be cleaned.The absorbent mop cloth picks up
the dirt loosened by the steam.Apply steam liberally.Keep a towel handy and wipe
away any excess water that may accumulate.
5)
When the steam mop stops emitting steam,simply turn OFF and unplug
the appliance,refill the Water Tank and continue cleaning.
NOTE: It is recommended that another high wattage appliance is not operated on
the same circuit to avoid a circuit overload.
CAUTION: To sanitize an area of your floor, leave the Steam Mop over area for a
minimum of 8 seconds, but no longer than 15 seconds. Leaving the Steam Mop in
a stationary position for a longer period than recommended may cause the build
up of a pale residue. This residue can be removed by using a decalcifying product
or with a few drops of vinegar. (See troubleshooting guide)
WARNING: NEVER run the Steam Mop without water. NEVER direct steam at
any person or animal. Use the Steam Mop on sealed hard floor only.
9) When you finish your cleaning, unplug Power cord from outlet, empty the Water
tank, carefully remove the cloth Pad from the head, wind Power Cord around the
Cord Wrap and store it upright in a dry area or hang by the storage hook.
CAUTION:
The Cloth Pad may be very hot.
Not for space heating purpose.
Warning:
1)
Don’t use the steam mop without Microfiber Cloth Pad on the mop head
2) Only attach the Carpet Glider to the Mop head when you clean the
Carpet.Carpet Glider is not used for the floors except Carpet.
3) When clean any sealed wooden floors,especially sealed lacquered floor,
use extra caution, pls clean small areas as an experiment in order to avoid
scratching and damage of floors.
